Investigation of Open End Yarn Tension Using an Elastic Yarn-Guide
Research and development
Authors:
- Shukhratov Sharof
Department of Materials Engineering, Faculty of Mechanical Engineering and Design, Kaunas University of Technology, Kaunas, Lithuania - Milašius Rimvydas (j/w)
- Gafurov Jakhongir
Department of Processing of Textile Materials, Jizzakh Polytechnic Institute, Jizzakh, Uzbekistan - Mardonov Batir M.
Department of Textile Industry Technology, Tashkent Institute of Textile and Light Industry, Tashkent, Uzbekistan - Gafurov Kabuljon (j/w)
- Repon Md. Reazuddin
Department of Materials Engineering, Faculty of Mechanical Engineering and Design, Kaunas University of Technology, Kaunas, Lithuania
Nr DOI: 10.5604/01.3001.0014.8230
 Full text | references | Abstract: This paper presents the results of Open End (OE) yarn tension investigation using a yarn-guide funnel with an elastic element. Obtained were the dependencies of tension change on such factors as body mass, elastic element rigidity, yarn coordinates on the funnel surface, and the speed of yarn moving. The values of these factors cause fluctuations in yarn tension and, consequently, in yarn structure and characteristics. On the basis of experiments, it was shown that due to using of a yarn-guide funnel with an elastic element, a decrease in yarn unevenness is achieved. It is easily regulated by the funnel mass, the rigidity rate of the elastic element, and the spinning speed. |
Tags:
OE, tension, elastic element, yarn-guide funnel, yarn unevenness, rigidity rate.
Citation:
Shukhratov S, Milašius R, Gafurov J, Mardonov B, Gafurov K, Repon R Md. Investigation of Open End Yarn Tension Using an Elastic Yarn-Guide. FIBRES & TEXTILES in Eastern Europe 2021; 29, 4(148): 43-47. DOI: 10.5604/01.3001.0014.8230